[Ocean]

Originally Posted by H2k

Hello

Fine

fetch_bbarray_cookie('thread_lastview', $thread['threadid']);

B4 ADD

// *********************************************************************************
// initialise some stuff...
$limitlower = ($pagenumber - 1) * $perpage;
$limitupper = ($pagenumber) * $perpage;
$counter = 0;
$threadview = fetch_bbarray_cookie('thread_lastview', $thread['threadid']);
$displayed_dateline = 0;

That's not the sole amount of code you're supposed to add at that point. You need to add everything BETWEEN



********************************
6. Above, Add:
**********


And this:


********************************

7. Optional Step: In the code you just added in the previous step, there is a Configuration Section. If you wish, you can modify this hack's behavior and permissions there. Instructions can be found within the Configuration Section.

********************************

Originally Posted by H2k

Know after i add this the last one u tell should i add the code from

// Section - Check if user has already viewed thread, and add UserID if they have not

TO

		//redirect back to Pop Up Window 
		$url = "showthread.php?$session[sessionurl]do=whoviewedpopup&t=$threadid"; 
		eval(print_standard_redirect('redirecting')); 
 
	}
 
 
 
}

this is i dont understand reasly what code i need to add in this part .. if u can tell me what code .. it will be easy my english is really bad.. and i hope that with your reply u can Tell me example after that put this code.. and iwill be done with this mod

No, you're not supposed to add anything. Those are not part of the instructions. That's part of the code you should have added in the previous step.

The instructions are all formatted in an identical manner - they are located between single lines of asterisks, and each instructional step is prefixed with that step's Number.

The problem is that you are not looking for where each instruction begins and ends - you are reading the middle of the code and assuming that it's part of the install instructions, which it is not.

There *is* a configuration section - but that is located within code that you are supposed to be adding. Step 7 indicates this, and tells you that you can optionally configure this hack's behavior by editing the Configuration Section - after it's been added in the appropriate place.