[Rhoads]

Originally Posted by noppid

I hear ya, I'm perplexed too!

If it were me on my test server I would just put in a few echo statements, spit out the variables, halt execution, and see what's happening.

Hard to tell what's up from here. :banghead:

hahaha, I have no idea how that would have all, but I think I can wait better, and look at there if more people with such problems, perhaps there still a solution comes.

Thnx for your help.

Oke there is well news

I tested it with the filesystem ,and now I have a watermark.
I think I go back to the database system and look again, and I have also a watermark.

The problem was that I used the lower part as a watermarked, if I use a file of 1024 x 768, the watermark is not visible because the lower part of the full screen is 1 cm shortened, when I do the watermark to the top, and upload a new screen, than it is visible. When I upload a screen about max of 600 x 400 , then you can see the watermark on the top and the lower part (exactly what you have filled in in the vbgconfig). The problem is therefore photograph larger than 600 x 400 , the watermark is only visible on top, and when you edit it to the lowerpart, it is not visible because he shortened 1 cm.

I hope that you understand me, because my English is not well :squareeyed:
Is it possible change altitude of the water mark ,so that I can use them to te lower part, but a little bit higher, I think that the problem then has been solved.

Thnx