^ Try this - https://vborg.vbsupport.ru/showthread.php?t=228319

I forgot to find that link yesterday and share so here it is today lol! Needless to say.. tinker with that three part header until you get the gist of how it works then you can adjust it to make your logos appear :D. You can position them using css only UNLESS one little part of the banner is clickable OR for example if you had a banner ad... it was for advertising a repair shop and only the wrench in the mechanics hand was clickable then you would use an image map or another way to go about it but if the entire rectangular banner is supposed to be a link to their site or a page in question then its easier to make the entire banner clickable and you can position them where you want using css only and not even mess with all that map stuff or even need to open your program.

*Don't forget, you can make a "child" style of another, then make changes there so the main style is not affected.

Thank you, much appreciated!

very very useful thanks for share this all information

Thank you.

Still a fantastic article.
Unfortunately never seen before. Thank you :)

I want to expand the width of some elements (to 100%), how would I go about doing this for the following areas?

Also, I want to expand the width of those general locations in the forumhome, showthread & showforum areas. Basically, (almost) everything that is in a table in these areas, should be set to %100 so that they resize to fit when someone zooms in & out on a mobile device.

Have you tried setting 100% in the doc_width style var?

Alright I've set

doc_width
doc_midWidth & MaxWidth to %100

Seems alot better with that change.