Quote:
Originally Posted by Princeton
(Post 1200202)
nearly identical to the one I wrote for a client ... great job
you should add print_cp_redirect()
|
:) thanks, I didnt know that you wrote one before. you wouldnt mind when I release it, do you?
How can I pass the "_POST" value for "message" into print_cp_redirect()? in my "donext" function, it is a form with informations to send.
Quote:
Originally Posted by dknelson
(Post 1200208)
There is one small thing that I don't care for. If I go to the usergroup to send a Mass PM....all the usergroups are selected by default. I have a LOT of usergroups because I am using this to send PMs to members in certain states/provinces. So...I have to de-select 60 or so groups and then select only the one or two that I want.
I wish that they were either not selected by default or a button to de-select all.
|
click on All Usergroups once to select ALL groups, and click again to de-select them
Quote:
Originally Posted by zappsan
(Post 1200292)
When I use BBCode, the URLs are mssed up.
I get URLs like http://\"http//piforums.info/showthread.php?t=3593\%22 for example...
edit:
Well, you need to make sure not to use any " for the URLs or it will show up like I stated above.
|
this is fixed in version 1.0.1
Quote:
Originally Posted by banuchi2
(Post 1200290)
Messages were not sent and it didn't allow me to go past the 500 original. Any ideas? The TEST worked and had the NEXT button, but not when it was actually sent.
|
Quote:
Originally Posted by banuchi2
(Post 1200298)
I figured this out.... I can send to 395 members and the NEXT button will be there. If I send to 396+, then the NEXT button will NOT be there.
The only other issue is that the message isn't actually sent even though it says it is. I logged in as some users that supposedly were sent a PM and they did not receive anything.
|
are you sure you install THIS hack, not the old one that I released yesterday, based on ZT's hack? This one is DIFFERENT, and the link is in Users section in your admincp, with the name " Send PM to Users"
In this one, there is ALWAYS a " Next page" button underneath the userlist, until when you finish sending PMs
I tried with 20000 members, 500 or 1000 members each page, and it works fine (with the "TEST" mode. the actual SEND supposed to do the same. I did not test sending to my 20000 members, but I dont believe there's any problem there. It works fine with my test board (with few registered accounts) |
More Information