Thank you for a great idea.

However, when I set the "Can do Stamps" permission to true, it is not saved, even when I save other permissions successfuly in the same session.

What should I do?

LATER ON: Saving permissions is OK after disabling and enabling the product. Voted and Registered. Thank you again for a great product.

any one can help ?

is cron working with you all ?

Regards,

great hack

thanks

I cannot seem to get this to work. It installs fine; but when I try to 'stamp' a thread from the drop-down list in Thread Tools on the thread, I'm given an error indicating I don't have access to do this (though mine is the admin account).

Any suggestions on how to get this to work?

https://vborg.vbsupport.ru/

It does not seem to work with me too, permissions cannot be saved ?!

weird place to put it

should of been done by usergroups

also when i stamp a thread no matter what location i select the stamp to go in i only get to see about half of the stamp.The rest is auto blocked out

also -shouldn't it be set up so that someone who does not have the ability to stamp a thread does not even see that option in the thread tools?

What finally worked well for me was to disable the MOD and then enable it again, at which time permissions could have been saved properly.

I did that and it didn't work!

what files you tried (fixed or normal) ?