I have a customized navbar. Can you tell me what to edit cause the plugin didn't do it for me.

See post #124...

I am normally okay with most hacks, been doing for 5 years, but do you think I can get this to show up? I have a a customized site also and I cannot get it to show up. I am using Automatic forum marking with DB, and have edited the href to my full forum path but still a no go, just will not show up in the user front end. Did I miss something, I read this thread in full, it took ages.

Nice feature, really would like it.
www.alfaowner.com/forum

Regards,

AO

I too have a customized site. This hack didn't work for me until I added

"</strong><br />" to the end of the "Welcome, xxxxxx." message.

This is referenced in post #124.

Actually "<br />" was aready there so I replaced it with "<strong></strong><br />" and I was good to go.

This is the appropiate line in the standard navbar ;

The bold bit being the important part, if that isn't there, this will fail to show.

Thank you! I will!

I have run into a little problem with this plugin in firefox. Quite often when I click on the unread posts it gives me a "page not found" error. Hasn't happened in IE.

I installed it and it works perfectly.

I use ff too. You should check the link that it goes to. It shouldnt have an issue if you use ie or ff as the link is created by vb and has nothing to do with the browser ie. http://www.domain.com/search.php?do=getnew

good luck.

Is there a way to exclude certain forumdis ?

worked on the first try. took about 6 seconds to install but is very helpful. thanks

installed